Build guide¶
Assembly, wiring and first power-up for the kit version. The assembled and tested version starts at Wiring.
RF safety
High RF power. Never operate without a proper load or antenna connected.
In the box¶
- [Controller board]
- [Display module + cable]
- [Connectors / harness]
- [Quick-start card]
Tools and parts you need¶
- [Soldering iron, solder, flux]
- [Multimeter]
- [Supply: voltage and current]
Assembly¶
[Assembly steps for Rev 4.01.]
[Assembly steps for Rev 4.02.]
Wiring¶
Wire the modules to the controller as shown in Connectors and wiring. It has the system diagrams, and a pin-out and wiring sketch for every connector.
Suggested order:
- 12 V supply (J22) and the display (J18).
- High Side Switch: sense (J8) and control (J10).
- LPF module: power (J39) and band select (J43 or J41).
- SWR bridges (J3, J5), NTCs (J28) and fan (J20).
- PTT and RX/TX relay (J26), PA bias (J30).
- Radio band data (J1 or J16), ALC (J24), and the optional antenna selector and rotator.
First power-up¶
- [Check supply polarity and voltage before connecting the board.]
- [Power up without the amplifier connected; the display should start.]
- [Continue with Setup and calibration.]