Skip to content

Build guide

Assembly, wiring and first power-up for the kit version. The assembled and tested version starts at Wiring.

RF safety

High RF power. Never operate without a proper load or antenna connected.

In the box

  • [Controller board]
  • [Display module + cable]
  • [Connectors / harness]
  • [Quick-start card]

Tools and parts you need

  • [Soldering iron, solder, flux]
  • [Multimeter]
  • [Supply: voltage and current]

Assembly

[Assembly steps for Rev 4.01.]

[Assembly steps for Rev 4.02.]

Wiring

Wire the modules to the controller as shown in Connectors and wiring. It has the system diagrams, and a pin-out and wiring sketch for every connector.

Suggested order:

  1. 12 V supply (J22) and the display (J18).
  2. High Side Switch: sense (J8) and control (J10).
  3. LPF module: power (J39) and band select (J43 or J41).
  4. SWR bridges (J3, J5), NTCs (J28) and fan (J20).
  5. PTT and RX/TX relay (J26), PA bias (J30).
  6. Radio band data (J1 or J16), ALC (J24), and the optional antenna selector and rotator.

Connectors and wiring →

First power-up

  1. [Check supply polarity and voltage before connecting the board.]
  2. [Power up without the amplifier connected; the display should start.]
  3. [Continue with Setup and calibration.]

Setup and calibration →