Skip to content

Getting started

The short path from a wired controller to a working amplifier. Each step links to the full instructions.

RF safety

High RF power. Never operate without a proper load or antenna connected.

  1. Wire it up. Follow Connectors and wiring. Power up on 12 V only, with the 52 V supply off, and check that the display starts.
  2. Set the current sensor. Choose the sensor type in the High Side Switch's power module settings (shunt, Hall or BTS) and enter its values.
  3. Set the LPF map. Tell the controller which LPF bank each band uses.
  4. Set the temperature sensors. Enter each NTC's resistance and beta, and the fan low and fan high temperatures.
  5. Set the protection trip levels. On the protection page, adjust the trimmers for voltage, current and temperature.
  6. Choose the band data source (band voltage, BCD, CAT, CI-V or RF sense) and your radio profile.
  7. Calibrate power and SWR, then test every protection trip into a dummy load before going on the air.

See Setup and calibration for each step in detail.

[TODO: add a short video once recorded.]